Services
Home batteriesSolar + battery systemsSolar panelsAdd a battery to solarEV chargersMain panel upgradesAll services →
Areas we serve
San FranciscoSan FranciscoNorth BayEast BayPeninsulaSouth BaySee every city →
Resources
Home & roof · Explainer

When are solar panels most efficient?

Bright light and cool air. Why output peaks around midday, why a cool spring day can beat a hot summer one, and what fog and heat mean for Bay Area roofs.

[Author name][Role, NABCEP credential]
Reviewed by [Engineer name]Updated [Mon YYYY][N] min read
In this article
The short answer
  • Time of day: output peaks around solar noon, when the sun is highest and light travels through the least atmosphere.
  • Season: long, bright days with cool air are best. In much of the Bay Area that means late spring.
  • Heat works against you. Panels lose a little output for every degree they warm above 25°C (77°F).

"Efficiency" gets used two ways in solar. The panel's rated efficiency is fixed at the factory: the share of sunlight it can turn into electricity under standard test conditions. What changes every hour is how much power the panel actually makes, which depends on how much light reaches it and how hot it gets. That second number is what drives your savings, and it follows a predictable pattern.

By time of day

Output rises in the morning, peaks around solar noon, and falls through the afternoon. At midday the sun is highest, so its light hits the panels more directly and passes through less atmosphere on the way. Solar noon is not exactly 12:00. During daylight saving time in the Bay Area it falls closer to 1pm.

Roof direction shifts the curve. South-facing panels produce the most over a full day. West-facing panels produce a little less in total but more in the late afternoon, which can be useful now that evening power is the most expensive.

By season

Summer has the longest days and the highest sun, so it usually produces the most energy per month. But the best days for efficiency are often in spring: long days, strong sun and cool air. Winter brings shorter days, a lower sun angle and more storms, so monthly production falls, sometimes to less than half of the summer peak.

Rule of thumb. Summer makes the most energy. Cool, clear spring days make it most efficiently.

Why heat lowers output

Solar cells are semiconductors, and they lose voltage as they warm up. Panel datasheets list this as a temperature coefficient, typically around a third to half a percent of output lost for every degree Celsius above 25°C. On a hot, still afternoon, a dark panel on a roof can run far hotter than the air around it, so the loss adds up.

That is why installers leave an air gap under the panels so they can shed heat, and why a breezy, cool day can beat a hot one with the same sunshine.

ConditionEffect on outputWhy
Clear, cool and brightHighestStrong light, low cell temperature
Clear and hotSlightly lowerCell temperature reduces voltage
Thin fog or high cloudsReducedDiffuse light only
Heavy overcast or rainMuch lowerLittle light reaches the cells
Partial shade on the arrayVaries by designMicroinverters or optimizers limit the loss to shaded panels
General patterns. Exact losses depend on the panel model and how it is mounted.

Fog and microclimates in the Bay Area

The Bay Area packs many climates into a few miles. San Francisco's west side, from the Outer Sunset to the Richmond, often sits under marine fog on summer mornings, while the Mission, Bernal Heights and the inland East Bay are already in full sun. Panels still produce in fog, just less, and many foggy mornings clear by early afternoon.

Inland, the opposite problem shows up: very hot summer afternoons, where heat trims a few percent from peak output. Neither is a reason to skip solar. Both are reasons to model production for your exact address rather than a regional average.

What would your block produce?

We model your roof from satellite imagery and local weather history.

Get my estimate

Efficiency versus value under NEM 3.0

Under NEM 3.0, when your panels produce matters as much as how much they produce. Midday surplus that goes to the grid earns a small credit, while power you buy from 4 to 9pm is the most expensive of the day. The most valuable solar is the solar you use yourself, either as it is made or later from a battery.

So the goal is not just peak efficiency at noon. It is capturing that midday peak and spending it in the evening. That is what a home battery does. Our NEM 3.0 guide explains the rules behind it.

See your roof's best hours.

A production model for your address, with a battery plan for the evening.

Get my estimate
CallGet my estimate